CS Instruments DS 300 mobile version, Instruction Manual

- 14 - 

Powered on device 

If DS 300 mobile version is powered on the display will show the following system 
information for approximately 5 seconds:  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Real-time measured values: 

The system information is helpful for any service 
inquiries in order to identify the specific model and 
version. 
 
This information can be called up at any time in the 
menu point "System status and settings" under 
"System status". 

If the sensors are connected to the right channels 
according to the DS 300 configuration, DS 300 will 
recognize them automatically and start to display 
real time measurement values acquired from those 
sensors. The measurement values may be 
displayed on more than one page. To see another 
page, just press the  
  
          or              button. 

Pipe 1 flow rate 
 

6.5 m³/h 

Pipe 1 consumption 
 

9 m³ 

 
 
                    Page 1 of 2 

   Back 

  Enter 

System information 
Device type: DS 300 
Serial no.: 00000237 
Firmware version: 2.18 
Hardware version: 2.04 
February/17/2009   08:52:31 
 
 
                    Page 1 of 2 

Back 

Enter 

DS 300-P4 and -P6 has 2 digital sensor inputs, channel 
1 and 2, for consumption or dew point sensors of CS 
Instruments.  
 
Additionally DS 300-P4 has 2 analogue inputs (channel  
3 and 4), DS 300-P6 has 4 analogue inputs for pressure 
sensors, temperature sensors or clamp-on ammeters of  
CS Instruments (channel 3, 4, 5 and 6).