VCC-HD3 Rev. 905-0051-Z0
©2016 CIS Corporation. All rights reserved.
6
5.
Part Names and Functions
①
C/CS Mount
To mount a C or CS mount lens.
To mount a C mount lens, keep the C/CS conversion ring attached. (Shipped from our factory with conversion ring
attached.) To mount a CS mount lens, remove the C/CS conversion ring.
Screw length from the lens mount surface shall be less than 6mm. And protruding portion of the lens shall be
less than 8mm. When lens is not mounted, please put the attached lens mount cap on.
②
DC IRIS Connector
Connector for DC IRIS lens
③
Connector for Power input, Gen Lock, and LTC signal input
Please refer to the external connector pin assignment.
④
Video Signal Output
With BNC cable, connect to a 3G-SDI input monitor or HD-SDI input monitor. (Analog monitors cannot
be connected.)
BNC cables with high frequency characteristics correspond to 3G-SDI or HD-SDI shall be used.
⑤
φ
3.5(4 poles) connector (RS-232C)
Connector
for
RS-232C
Please refer to the external connector pin assignment.
Please refer to the other materials for the details on serial communications.
* Do not connect it to any audio equipment such as earphones and headsets.
Connecting to such equipments may cause malfunction.
⑥
Screw Holes for camera installation
4 screw holes to install the camera.
Please be noted that the depth of the front screw holes and the rear screw holes are different.
