XCP-Gateway
Product Description
User Guide
6
Version 01.00
User Guide
3.1.1 Connectors and components
The following figures show the device XCP-Gateway with its connectors.
Fig. 3-1: XCP-Gateway, front view
1. PC socket (
2. EtherCAT socket (
chapter 4.3.2.2 "ECAT socket")
3. ECAT (Ethernet) indicator LED (
chapter 3.1.2.1 "Indicator LEDs “PC” and “ECAT”")
4. PC (Ethernet) indicator LED (
chapter 3.1.2.1 "Indicator LEDs “PC” and “ECAT”")
5. Gateway status LED (chapter
3.1.2.2 "Status-LEDs “Gateway” and “Bus”")
6. Bus status LED (chapter (chapter
3.1.2.2 "Status-LEDs “Gateway” and “Bus”")
7. Hardware serial number
8. Sync / service connector (chapter
4.3.2.3 "Sync / service connector")
Fig. 3-2: XCP-Gateway, rear side
1. Threaded mounting holes for screws M4 x 8 mm
1
2. Cable tie eyelets
3. GORE
membrane ventilation inlet
See chapter 4.1 “Before mounting the device” for detailed information.
1
The specification “M4 x 8 mm” only applies if a standard mounting angle from the product range of CSM MiniModule accessories
is used. In this case, the screw length may not exceed 8 mm. In case of combination with any other mounting material, a different
screw length may be required.
3
Co
nn
ect
ion
ca
ble
1
1
2
2
1
1
2
2
2
1
7
6
5
4
3
8
Summary of Contents for XCP-Gateway
Page 2: ......
Page 4: ...XCP Gateway User Guide ii Version 01 00 User Guide ...