XCP-Gateway
Safety Instructions
User Guide
4
Version 01.00
User Guide
2
Safety Instructions
2.1
General safety instructions
The device XCP-Gateway has been designed and manufactured to comply with the relevant safety
standards. The product is manufactured in due consideration of the standards of an ISO 9000 Quality
Management System.
NOTICE!
Proper functioning and electrical safety can only be ensured if the device is
correctly installed.
Make sure that the device is properly installed.
Operate the device only within the specified operation environment.
See datasheet “XCP-Gateway” for further technical information.
2.2
Operator’s obligation
The operator has to make sure that the product is only handled by qualified and authorized personnel.
This applies to all phases of the product life cycle.
In addition to the technical documentation of the product, the operator may have to provide further
operating instructions in compliance with the Act on Occupational Safety and Health.
2.3
Intended use
XCP-Gateway has been designed for fast and time-equidistant acquisition of measurement data from
CSM MiniModules using software based on the protocol XCP on Ethernet.
The device may only be used for the above-mentioned purpose and under the operating conditions
defined in the technical specifications.
See datasheet “XCP-Gateway” for further technical information.
The operational safety of the XCP-Gateway device can only be ensured if the device is used in
accordance with its intended use.
Compliance with the intended use also includes reading this user manual carefully and observing all
the instructions contained.
Inspection and maintenance work may only be carried out by CSM.
The operator bears full responsibility if this device is used in any way that does not comply strictly
and exclusively with the intended use.
Summary of Contents for XCP-Gateway
Page 2: ......
Page 4: ...XCP Gateway User Guide ii Version 01 00 User Guide ...