XCP-Gateway
Mounting and Installation
Version 01.00
0
11
User Guide
4.3
Installing XCP-Gateway
4.3.1 Before installing the device
NOTICE!
XCP-Gateway has been especially designed for use in combination with
CSM EtherCAT measurement modules.
XCP-Gateway cannot be operated in combination with devices from
third-party manufacturers.
Make sure that only CSM EtherCAT measurement modules are applied.
Make sure that this work is only carried out by qualified and trained
personnel.
CSM offers a wide range of cables for connecting ECAT devices. See
datasheet “CSM MiniModule Accessories” for details or contact the CSM
sales department for further details.
CSM provides a repair service for the XCP-Gateway.
See chapter 6.1 “Maintenance and repair” for details.
4.3.2 Connectors
The two sockets embedded on the left side of the device housing’s front panel are used for connecting
the XCP-Gateway to the data acquisition system
PC
on the one hand and to the EtherCAT measurement
modules
ECAT
on the other hand. Via the so-called interface cable connecting the XCP-Gateway with
the data acquisition system, the device is also connected to the power supply by using the cable’s
banana connectors. The power supply is wired through from the
PC
socket to the
ECAT
socket, i.e. the
EtherCAT measurement modules receive their supply voltage via the XCP-Gateway. If more than one
XCP-Gateway or further interfaces (e.g. control units) are connected to the data acquisition system, the
3-pole sync/service socket can be used for time synchronization and drift compensation of the
connected XCP-Gateways and further devices.
Summary of Contents for XCP-Gateway
Page 2: ......
Page 4: ...XCP Gateway User Guide ii Version 01 00 User Guide ...