XCP-Gateway
Applying XCP-Gateway
Version 01.00
0
21
User Guide
5.2.3 Online configuration
5.2.3.1 Preparing configuration
Before starting the configuration make sure that
the ECAT measurement modules and XCP-Gateway are properly connected
XCP-Gateway is properly connected to the data acquisition PC
It is advisable always to use the latest version of xx-Scan Config. Specific
technical information can be found in the download area of the CSM
website.
5.2.3.2 Starting xx-Scan Config and selecting the communication interface
Start up xx-Scan Config.
The xx-Scan Config program window opens (the last configuration used during the previous
session may be displayed).
Fig. 5-11: xx-Scan Config program window
If no communication interface has been selected yet, the message
No valid Interface selected
appears
in the status bar (see Fig. 5-11).
After the program has been started, xx-Scan Config checks the communication interfaces for
available connections. These connections are listed in the
Interface
dialog.
Fig. 5-12:
Options | Interface
menu
Click on
Options | Interface
(
Ctrl + I
).
The
Interface
dialog opens.
Summary of Contents for XCP-Gateway
Page 2: ......
Page 4: ...XCP Gateway User Guide ii Version 01 00 User Guide ...