CSSN MagShell 900, Install Manual

1. 

System Requirements

Before you use the USB devices, make sure your computer is an IBM PC-compatible with the 

following minimum system requirements: 

1.  Intel-compatible 486DX-66 MHz CPU or higher 

2.  One standard USB port (4-pin) and has the symbol 

3.  Either the following operating systems: 

Windows 95 OSR2.1 (B version) with USB version 1214, Windows 98, Windows 98 SE, 

Windows 2000, Windows XP and RedHat Linux 7.3 (kernel 2.4.18-3), RedHat Linux 8 (kernel 

2.4.18-14), RedHat Linux 9 (kernel 2.4.20-8.) 

2. 

Driver Installation

Follow the steps below on installing the USB devices for the first time: 

1.  Power on computer where you will connect the USB devices and make sure that the 

USB port is enabled and working properly. 

2.  Plug in the USB device signal cable into the USB port and Windows will detect an USB 

Device and run the 

Found New Hardware Wizard (For Windows 2000 / XP)

 or 

Add 

New Hardware Wizard (For Windows 98)

 to assist you in setting up the new USB 

Composite Device. 

3.  Insert the shipping disk into the CDROM device. 

Note, before beginning driver installation, please make sure the old driver had been 

removed. 

For Windows XP 

2 of 13