z
Do not lift the module by grasping the module’s junction box or electrical leads. Do not stand or
step on module. Do not drop module or allow objects to fall on module. Do not set the module
down on any hard surface.
z
To avoid glass breakage, do not place any heavy objects on the module. Inappropriate transport
and installation may break module.
4
、
Wiring and connection
z
Before this procedure, please read the operation instructions of the PV control system carefully.
z
Make wiring by Multi-connecting cables between the modules in series or parallel connection,
which is determined by user’s configuration requirement for system power, current and voltage.
And please refer to page 4.
⑵
Safety precaution for installing a solar photovoltaic system.
z
Open the connection box of the control system and connect the cabled from the PV arrays to the
connection box in accordance with the installation indication of the PV control systems.
z
Each module has two 4mm2 diameter type
（
12AWG
）
standard 90°C sunlight resistant output
cables each terminated with plug & play connectors. This cable is suitable for applications where
wiring is exposed to the direct rays of the Sun. We recommend that all wiring and electrical
connections comply with the appropriate national electrical code.
z
For field connections, use the minimum
Φ
4mm
2
diameter copper wires insulated for a minimum
of 90°C and Sunlight resistant as well.
5
、
Maintenance and Care
z
A built up of dust or dirt on the module(s) front face will result in a decreased energy output.
Clean the panel(s) preferably once per annum if possible (dependant on site conditions) using a
soft cloth dry or damp, as necessary.
z
Never use abrasive material under any circumstances.
