Chapter 5: Maintaining and Troubleshooting the RS Monitor
Resolving Common Problems
PowerStation RS Monitor User Guide
65
Image extends beyond the screen
1. The horizontal and/or vertical position is not correct for the
current video mode. Use the OSD Horizontal Position and/or
Vertical Position adjustment to center the image on the screen.
2. The horizontal size is not correct for the current video mode.
Use the OSD Horizontal Size adjustment to fit the image
completely on the screen
Characters shimmer or appear fuzzy
1. The clock phase for the current video mode is not correct. Use
the OSD Phase adjustment to sharpen the image.
2. The horizontal size is not correct for the current video mode.
Use the OSD Horizontal Size adjustment to fit the image
completely on the screen.
Important
This problem may occur if the horizontal size is mis-
adjusted by as little as one pixel too few or too many, so try
to make as precise an adjustment as possible.
3. The current vertical refresh rate may not be optimal. If your
computer’s video card and driver will support it, change the
vertical refresh rate until you find one that looks best with the
monitor.
When video mode is changed, the screen image
shifts left or right
The image’s horizontal position has not been optimized for the
new video mode. Use the OSD Horizontal Position adjustment to
center the image horizontally on the screen.
Note
This adjustment is saved for each video mode individually,
so you may have to make the adjustment for each video
mode you use. However, you will only have to adjust once
for each video mode since the adjustment will be saved
permanently by the computer.
