8
CTC EcoPart 400
General information
Important to remember!
Check the following points in particular at the time of delivery and installation:
• The product must be transported and stored in a standing position.
When moving the product, it can be placed temporarily on its back.
• Remove the packaging and check before installation that the product
has not been damaged in transit. Report any transport damage to the
supplier.
• Place the product on a solid foundation, preferably made of concrete.
If the product needs to be placed on a soft carpet, base plates
must be placed under the adjustable feet.
• Remember to leave a service area of at least 1 m in front of the
product.
• The product must not be placed below floor level either.
• Avoid placing the product in rooms where the walls are of lightweight
design, as people in the adjoining room may be disturbed by the
compressor and vibrations.
• Ensure that pipes used between the heat pump and the heating system
are of adequate dimensions.
• Ensure that the circulating pump has sufficient capacity to pump the
water to the heat pump.
Safety Instructions
The following safety instructions must be observed when handling, installing
and using the heat pump:
• Close the safety switch before doing any work on the product.
• Correct flushing of the system shall be carried out before the system is
filled with a recommended brine/heating fluid.
• When handling the product with a hoist ring or similar device, make
sure that the lifting equipment, eyebolts etc. are not damaged. Never
stand under the hoisted product.
• Never jeopardize safety by removing bolted covers, hoods or similar.
• Never jeopardize safety by deactivating safety equipment.
• Any work done on the product’s cooling system should be done by
authorised personnel only.
• This product is intended for indoor installation only.
!
If these instructions are not followed when installing, operating and maintaining
the system, Enertech’s commitment under the applicable warranty terms is not
binding
