12
High speed coin counting operation instructions
How to replace the V-belt
§
Open the upper cover, pull the Front
Feed Pulley Arm upward, then remove
the V-Belt 322 and V-belt 564 from the
machine, then, put on a new V-Belt on
the Pulleys.
§
The tension of the Feed Belt can
be adjusted by adjusting the position
of the nut
j
.
§
The height of the Front Feed Pulley can
be adjusted by adjusting the position
of screw
j
.
§
The height of the Rear Feed Pulley can
be adjusted by adjusting the position
of the screw
k
.
§
Then tighten the nut
j
, nut
k
& nut
l
.
§
Remove the Rubber Washer on the
Plastic Pedal; unscrew the four screws
in the Plastic Pedal.
§
Unscrew the screw 1 and screw 2, rotate
the Coin outlet Chute, then you can
screw off it from the machine.
§
Pull the Bottom Cover upward; remove
the Bottom Cover from the machine.
§
Remove the V-belt 350 and fix a new
belt on the pulley, the tension can be
adjusted by adjusting the position of
the Pressure Roller Base.
*** In the interests of our policy of continual product improvement, specifications are
subject to change without notice ***
