Aerial work platform
B-LIFT 18 HV
5
COD. UM0287_GB | REV. 0.0 | ED: 09/18
Chapter 4
GB
CONTROLS
Elemento
Descrizione
6
Movement speed proportional lever control;
•
operating the lever after actuating the required command (1, 2, 3, 4)
carries out the movement proportionally.
7
Emergency button;
•
Pressing the emergency button disables all the controls and the vehicle
engine switches off.
8
Work platform centring indicator;
•
This light stays on during operation. If it switches off (buzzer activation),
it indicates the risk of collision against the structure.
9
Red “command block” indicator;
•
lashes when the controls in the basket are blocked.
10
Light chain status
;
•
lights up when there are problems with the chains.
11
Three position spring-return to centre selector switch, powers the motor
on command;
•
keep the selector in the up position (ON) to start the motor;
•
keep the selector in the down position (OFF) to stop the motor.
12
Three position key selector switch
:
•
turn the key to the right to enable the mobile control console;
•
turn the key to the left to enable the controls in the working platform;
•
turn the key to the central position to disable the mobile control console
.
13
Console fastening system
;
•
the control console can be removed by unscrewing the two fastening elements
on the control box
.
14
Homing button;
•
keep pressed to retract the elevating work platform completely.
CAUTION
The working platform should only be controlled from the ground control panel
in case of an emergency.
Refer to the chapter regarding emergency manoeuvres.
CAUTION
The stabilizer indicator lights come on when the plate has reached its minimum
extension and is in contact with the ground, but they do not indicate that the
machine has been properly stabilized. Use the spirit level to check that it is
positioned correctly.
