Aerial work platform
ZED 20.3 HV
17
COD. UM0284_GB | REV. 0.0 | ED: 09/17
Chapter 8
GB
MAINTENANCE
8.12
Cleaning
To prevent the operator from slipping and falling, keep all handles and step clean from oil, grease
and dirt.
When cleaning the platform, properly protect electrical components and connections from water jets.
After cleaning perform lubrication on the parts.
8.12.1
Washing
The frequency of cleaning depends upon use of the machine. The machine can be washed using a
high-pressure water jetting machine, taking the following precautions:
•
do not exceed a temperature of 70°
•
use neutral detergents;
•
do not use solvents or benzene
•
keep at a safe distance when using the jetting lance
•
do not direct the jet towards control panels and electrical equipment
•
do not clean the machine of there is live electrical equipment
•
wear suitable personal protective equipment
•
only clean the machine in areas speciically set aside for the purpose and dispose of materials
in accordance with the provisions of the law.
CAUTiOn
after each wash, you must grease and lubricate all the parts indicated in section
8.5.
8.13
Paintwork inspection
All the parts and components of the lifting platform are protected from atmospheric agents by a coat
of paint or other surface treatments.
The paintwork also needs to be inspected continuously because if it is kept in good condition
it will ensure the long life of the platform.
If the paint is damaged, touch up the area immediately.
Before each use, the end user/authorised service centre should systematically check that the protective
treatments are not damaged.
If necessary, restore the protective coating.
