2
User & installation instructions
CTEK E-Mobility AB
Content
CHARGESTORM® CONNECTED ...... 2
Product description ...................... 2
Intended use .................................... 2
In the box ................................................ 2
Overview ................................................. 2
Status symbols ............................... 3
To charge the vehicle ......................... 4
Open access & RFID access ...... 4
To connect CHARGESTORM® CONNECTED
to the vehicle ................................... 4
To start charging with open access 4
To start charging with RFID access 4
Installation ............................................ 5
Introduction ...................................... 5
Safety ................................................. 5
Optional equipment ....................... 5
To check before installation ....... 5
To prepare the location for installation
5
To install the charging station on a wall
5
To install the charging station on a pole
6
To do the cable installation ........ 6
To install the power cable ........... 6
To install the network cable and the 3G-modem
(optional) ............................................7
To finish the installation ...............7
To change the configuration settings
8
To do a installation tests ............. 9
To do maintenance tests ............ 9
To recycle the product ................. 9
Technical data .....................................10
Intended use
This charging station is intended for wall-mounted or pole-mounted use.
The charging station is intended for both restricted and non-restricted locations.
In the box
1
2
3
4
5
6
7
8
9
10
1.
The charging station CHARGESTORM® CONNECTED.
2.
Two keys.
3.
User and installation instructions.
4.
Cover for cable inlet and cable glands (M25 and M12).
5.
Holder for charging connector (for variants with fixed cable).
6.
Insulation tube.
7.
Four mounting screws.
8.
Four rubber gaskets.
9.
Four metal gaskets
10.
Jumper (for variants with one phase)
Overview
1
2
3
4
5
6
1.
Front panel.
2.
Display with charging status symbols.
Overcurrent and short-circuit
protection ........................................10
Part specific data ..........................10
CTEK E-Mobility warranty statement 11
Limited warranty ............................11
Circumstances that will void the limited warranty
11
Additional information..................11
National usage restrictions .......11
Copyright ................................................11
Revisions ...........................................11
Abbreviations .......................................11
Electrical schematics ........................11
CHARGESTORM® CONNECTED
Product description
CHARGESTORM® CONNECTED is a multi usage station for electrical vehicles.
The charging station comes in several variants, such as for different output
power and number of outlets. For a complete list of article numbers, download
datasheet at www.ctekemobility.com.
NOTE:
Refer to the top of the charging station for model information.
CHARGESTORM® CONNECTED 2 is an improved and updated version of our
advanced EV charger with a range of functions and built in safety features. It
has a powerful charge controller, which can handle dual type 2 outlets/charging
cables and offers load balancing support through NANOGRID™.
Overheating protection
At high temperatures the charging station's algorithm will determine the optional
current. This reduces the risk of overheating and damaging the charging station
without preventing the use of the device.
