DOC00101-01
2-19
CTPhone 1900 System Planning
3
Enter 10 and then press
to access the system configu-
ration. The LED displays SYSTEM CONFIG.
4
Press
again. The LED displays SID #0.
5
Enter 7171.
6
Press
(located to the right of
). The LCD displays
HID #0.
7
Enter 1.
8
Press
. The handset returns to idle.
9
Repeat steps 2-8 of the Handset Set-up procedure, substitut-
ing a different number for the HID # (for example, choose 2,
3, 4, 5, etc.) in Step 7, for each additional handset.
+
Audio Coverage Test:
Step
Procedure
1
Press
to turn on the handset.
2
Press .
3
Listen for a continuous tone in the handset speaker while
walking around the facility observing the coverage area
boundaries.
Mark the floor plan where:
•
the continuous tone warbles (indicating the beginning of
a hand-off overlap area).
•
the continuous tone breaks or stops (indicating the end of
the coverage area).
4
Press
to return the handset to the idle state.
+
Handset Bit Error Rate (BER) Test:
Note
This is an optional test. Refer to Bit Error Rate (BER) Testing
on page 5-14 for additional information.
Step
Procedure
1
With the handset in the idle state, enter ## **
+
Handset Set-Up (continued)
FCN
FCN
ABC
END
PWR
CALL
END
Summary of Contents for CTPhone 1900
