www.ctronicssecuritycameras.com
21
1
、
The power supply of this product should be DC12V-14V, please use matched
power from our company to supply
；
2
、
Forbid turning around by outside force whether power on or off
3
、
Dial switch is on the bottom of the ball cover. Open buckle, you can adjust the
address code and baud rate. Please don’t open without permission
4
、
In order to ensure the precision of preset position, please set left and right limit
position before setting preset position. Make sure the preset position in limit
range
；
5
、
If the preset position come to off normal after long time of auto tour, power off
or outside force, by “calling 107 preset position ”command to reset the dome to
normal state;
6
、
In order to control the infrared light calorific value effectively and ordinary
infrared machine “flashlight” phenomenon independent control, switch the lens
at 11 times, so if there is one set of lamp off, are all normal phenomenon.
Because the IR light off means they are under a state of rest when the
irradiation angle and the current camera viewing angle are not consistent.
7
、
The preset setting of this camera with lens preset position as the same as
ordinary high-speed dome camera. As for setup method, please refer to “preset
position settings”
8
、
The camera outlet is directly high temperature conductive ring lines avoid
interface, please don’t pull output cable.
