22
MCT-RACK(config-output-No.)#
event lan-port
Enable LAN port alarm
MCT-RACK(config-output-No.)#
event power [a | b]
[a | b]
Specify power source and enable
power alarm.
MCT-RACK(config-output-No.)#
trigger
Enable digital output event.
No command
MCT-RACK (config)# no digital
input 1
Undo the status of electrical circuit for
the digital input number specified.
MCT-RACK (config)# no digital
output 1
Undo the status of electrical circuit for
the digital number specified.
MCT-RACK (config-output-No.)#
no event digital-input 1
Specify digital number and disable the
alarm of digital output specified.
MCT-RACK (config-output-No.)#
no event lan-port
Specify LAN port and disable the
alarm of digital output specified.
MCT-RACK (config-output-No.)#
no event slot [slot_list]
[slot_list]
Specify slots and disable slot alarm.
MCT-RACK (config-output-No.)#
no event slot [slot_list] [port_list]
[slot_list]
[port_list]
Specify TP/FO port on media
converters and disable port alarm.
MCT-RACK (config-output-No.)#
no event power [a | b]
[a | b]
Specify power source and disable
power alarm.
MCT-RACK(config-output-No.)#
no normal
Undo the status of electrical circuit for
the digital output number specified.
MCT-RACK(config-output-No.)#
no trigger
Disable digital output event.
Show command
MCT-RACK (config)# show digital
input
Show digital input configuration.
MCT-RACK (config)# show digital
input status
Show digital input status.
MCT-RACK (config)# show digital
output
Show digital output configuration.
MCT-RACK (config)# show digital
output status
Show digital output status.
MCT-RACK (config-output-No.)#
show
Show the designated digital output
status.
2.6.5 IP Command
This is to configure IP address.
1. Set up or remove the IP address.
IP command
Parameter
Description
MCT-
RACK(config)# ip
address
[A.B.C.D]
[A.B.C.D]
Enter the desired IP address for the Chassis.
[255.X.X.X]
Enter subnet mask of your IP address.
[A.B.C.D]
Enter the default gateway address.
