INST 428 CTX PROFESSIONAL E Series Salt Chlorinator V02.17
5
WARNING
: Cell must be installed horizontally with water connections pointing downwards - this
creates a safety gas trap. Installation in any other way may cause explosion, injury or
death.
WARNING
: Cell must be installed in the return pipework to the pool. Always install after filter, gas
heater, and solar heater or heat pump connections.
WARNING:
DO NOT install isolation valves on inlet or outlet of cell.
Once the Cell is located, connect the black multi-core cable to the cell. The blue wire must be
connected to the blue terminal. The cable is designed to come from below the cell. Make sure wing
nuts are correctly tightened to ensure good contact.
4.0 POOL PREPARATION
The recommended salt level for the CTX PROFESSIONAL E-SERIES Salt Chlorinator is 6,000ppm. The chlorinator requires
between 4000ppm and 6000 ppm of salt dissolved into the pool water. The level of salt will depend on water temperature,
but if a level of 6000 ppm dissolved salt is allowed for, your chlorinator will always be able to produce the maximum level of
chlorine. We recommend you add 6 kgs (13 Ibs) of salt for every 1000 liters ( 260 USG) of water (a typical pool of around
50,000 liters (13,000 USG) requires 300kg (660 Ibs) of salt).
Salt should always be added at the shallow end of the pool and allowed to dissolve. Running the pump will mix the water and
speed the dissolving process.
WARNING: Never add salt to the skimmer box!!
NOTE: Plug the pump directly into a power outlet (bypass the Chlorinator) and run for 8-10 hours to ensure the salt is
dissolved prior to running the chlorinator.
When the salt is dissolved, connect the pump to the chlorinator and run it on maximum chlorine output. Check that low
salt is not indicated on the screen. If it is, check again in 24 hours. If the low salt indicator still persists, have the salt level
checked by your local pool shops and ensure it is increased to 6000 ppm.
Summary of Contents for E Series
