Cub Cadet 21131508, Operator'S Manual

28

3. Make sure all shields are in place and in good 
    condition. Repair or replace any missing or damaged 
    shields.

7. Check for wear or deterioration of the upper or lower 

6. With the engine off, engage the blower assembly. 

    hoses. If there are any portions of the hose that have 

    loose parts, damaged bearings, or other damage. 

    Check the belt tension and inspect the pulley belt for 

4. Perform lubrication per paragraph 4-2.

5. Listen for abnormal sounds, which might indicate 

    Correct any deficiency before continuing operation.

    cracks or tears.

    replacement component installed during repair shall 

    by the manufacturers to be affixed to the component.

After Each Use:

    been torn or worn through, replace with genuine 

    container, underneath the belt shields, and safety 
    decals. Replace any missing or illegible decals.

2. Inspect the unit for worn or damaged components. 

    PECO parts.

    Repair or replace before the next use. Any 

    include the component’s current safety decal specified 

1. Clean all debris from machine especially from the 

3. Check belt for proper tension.

WRITE THE MODEL AND

SERIAL NUMBER IN THE

BOX ABOVE FOR FUTURE

REFERENCE.

THE SERIAL NUMBER PLATE

IS LOCATED ON THE TOP

ASSEMBLY 

MODEL: 59A30044150

SERIAL: ____________

R0008

Address: 

 _____________________________________ 

State:

  __________   Zip:__________

Unit Model Number:

  _____________________________

Dealer/Distributor Name:

  ________________________________________

Unit Serial Number:

  _____________________________

Unit Engine Size:

_____________________________

Date of purchase: 

_____/_____/_________

Phone Number:

  ____________________________

      a greasable fitting.

Operators are recommended to check for leaks weekly. 
If a leak is observed, both the gasket and the seals are 
recommended to be replaced. 

  NOTE: 

The gearbox is filled with 6.0 oz. of Mobilube 

HD Plus 80W-90 oil and permanently sealed. There is 
no need for scheduled lubrication. The oil level should 
only be checked if a leak is observed or if a change in 
gearbox noise is noticed.

Collection system owners should record the name and 
telephone number of their Service Center. Your Service 
Center will be happy to supply replacement parts, 
accessories, and do any service or repairs to your 
collection system. If for any reason your Service Center 
is unable to service your collection system or supply 
replacement parts, contact New PECO, Inc. and include 
the following information on the chart below. 

4-2 Lubrication

  NOTE: 

The following is for older PTO models that

      lubrication of the shaft on the blower assembly.

.

      contain maintenance-free bearings and are without

SECTION V - PARTS & SERVICE

Gearbox:

Replace the oil using 5.5 oz. of the recommended 
Mobilube HD Plus 80W-90 oil. Be sure to not overfill.

5-1 Parts And Service Information

  NOTE:

 Use only white lithium based grease for 

      contain a greaseable zirc fitting. Newer models 

  1. On initial use: Grease the fitting on the blower shaft.
  2. Every 25 hours of use: Re-grease the grease fitting.

Blower Assembly: