4
4.
Mount the winch mount bracket (8) to the
winch support plates (4) using a hex screw (11)
and flange lock nut (14) as shown in Figure 4.
Snug, but do not fully tighten the hardware.
8
4
4
11
11
14
14
Figure 4
5.
Secure the front of the winch mount
bracket (8) to the two bumper support
brackets using two flange lock nuts (15) and
hex flange lock bolts (10). See Figure 5.
15
10
8
15
10
Winch Not Shown For Clarity
Figure 5
6.
Insert the fairlead mount bracket (9) with
the top mounting holes to the inside of the
front bumper and the lower mounting holes
outside of the front bumper. See Figure 6.
9
Figure 6
7.
Secure the fairlead mount bracket (9) onto
the front bumper using four hex screws (11)
and four flange lock nuts (14). See Figure 7.
9
11
11
14
14
Winch not shown for clarity
Figure 7
8.
Install the fairlead winch attachment (2)
onto the fairlead mount bracket (9) with two
hex screws (11) and two flange lock nuts (14)
as shown in Figure 8.
14
2
11
9
Figure 8
9.
Remove either the upper or lower clevis pin in
the fairlead winch attachment (2) by removing
the cotter pin and sliding the clevis pin out.
Feed the hook on the winch (1) through the
fairlead winch attachment (2).
10.
Reinstall the clevis pin and cotter pin in the
fairlead winch attachment (2).
11.
Securely tighten all the hardware.
12.
Measure 6 feet from the winch control (3)
down the wire harness and using a
P-Clamp (18), mount the wire harness to the
container bracket (7) upper hole with a hex
screw (19). See Figure 9.
18
7
19
18
19
6-feet from
Winch Control (3)
Winch Control (3)
Figure 9
13.
Secure the lower P-clamp (18) and wire
harness to the lower hole of the container
bracket (7) with a hex screw (19). See Figure 9.
14.
Install the container bracket (7) to the utility
vehicle frame under the driver’s seat using
two hex screws (13). See Figure 10.
7
13
13
Left Side
To Back
Figure 10
15.
Install the panel latch assemblies into the
underseat storage container (6). Insert
the spring clip (26) into the compression
spring (25), push the spring clip (26) and
compression spring (25) up through the
hole in the underseat storage container (6)
pushing up until the 1/4-turn panel latch (17)
can be hooked onto the spring clip (26). See
Figure 11. Install both panel latch assemblies
in the underseat storage container (6).
26
25
6
17
Figure 11
16.
Insert the underseat storage container (6)
into the container bracket (7) and secure the
underseat storage container (6) with two
plastic rivets (12) as shown in Figure 12.
6
Left Side
12
To Front
12
Figure 12
