8
S
ection
2 — A
SSembly
& S
et
-U
p
2.
Place chute assembly onto chute base
and secure chute control head to chute
support bracket with clevis pin (c) and
cotter pin (d) removed in Step 1.
See Figure 2-14.
(c)
(d)
Figure 2-14
3.
Finish securing chute control head to
chute support bracket with wing
nut (a) and hex screw (b) removed in
Step 1. See Figure 2-15.
(a)
(b)
Figure 2-15
4.
Insert chute control rod into the support
bracket on rear of the dash panel. See
Figure 2-16.
Figure 2-16
5.
Remove hairpin clip (a) from rear of
chute control head. See Figure 2-17.
(a)
(b)
Figure 2-17
6.
Insert chute control rod (b) into rear
of chute control head. See Figure 2-17.
Secure chute control rod to chute
control assembly with hairpin clip (a)
removed in Step 5.
STOP
Continue to Set-Up (page 12).
Overhead Chute Control (w/
Chute Control Rod)
Overhead Chute
Control Rod
Chute Assembly
Figure 2-12
1.
Remove wing nut (a) and hex
screw (b) from chute control head and
clevis pin (c) and cotter pin (d) from
chute support bracket. Position chute
assembly (forward-facing) over chute
base. See Figure 2-13.
(a)
(b)
(c)
(d)
Chute
Support
Bracket
Chute Control
Head
Chute
Chute Base
Figure 2-13
