Cub Cadet 59A40003727, Operator'S Manual

14

figure 12

•  Using the hydraulic control lever, fully cycle all cylinders 

several times to purge air from the hydraulic system. After air 
has been purged from system, roll the bucket back and lower 
to the ground.

•  Check the tractor’s transmission oil level as instructed in 

tractor Operator’s Manual. Refill the transmission to the full 

mark before operating the tractor and/or the loader. When 

adding oil to the tractor transmission, always use the type of 
oil specified for the tractor. NEVER MIX OIL TYPES.

figure 11

•  When the masts are firmly settled into the tower mounts, 

continue to slowly push the control lever forward, and to the 
right, to raise the loader hitch bracket upward into the front 
mount receiver. As the loader hitch bracket is raised, the 
boom cylinder pivot pins should also rotate back into the 

notches of the RH and LH mounts. Refer to Figure 11. Drive 

the tractor forward as necessary.

nOTe:

the loader hitch bracket must fit squarely in the front 

mount receiver to allow installation of the mounting pins. if the 
hitch bracket does not fit squarely in the channel of the front 
receiver, loosen the hex screws and lock nuts fastening the loader 
hitch bracket to the RH and lH loader hitch arms. again, use 
the implement control lever to raise the loader hitch bracket fully 
upward in the front mount receiver. Re-tighten hex screws and 
lock nuts to secure the loader hitch bracket.

•  When the strut of the loader hitch bracket is fully up inside the 

front mount receiver, re-insert the two mounting pins removed 
earlier. Secure the mounting pins with the two lynch pins.

•  Disconnect the overhead lift apparatus from the front loader.
•  Route the hydraulic hoses forward along the inside of the RH 

loader hitch arm and place the hoses between the loader arm 
and the hook of the hose retainer rod; then loop the hoses 

rearward and place the hoses between the RH loader mast 
and the second hose retaining rod. Refer to Figure 12.

Lynch Pin

Mounting

Pin

Front Mount

Receiver

Loader Hitch

Bracket

LH Mount

LH Mast

Support

Plate

Hose Retainer Rod