Cub Cadet 59A40003727, Operator'S Manual

15

•  Continue raising the boom until center points of the support 

plates on the bottom of the loader hitch bracket are resting 
on the ground, the loader hitch arms and bucket are support-

ing the weight of the loader, and the bottom of the RH and 
LH masts have lifted off the tubular bars of the RH and LH 
mounts. Refer to Figure 13. 

•  Stop the tractor engine and engage the parking brake.
•  Disconnect the loader hoses from the tractor’s hydraulic 

couplers by pushing inward the locking collar on each female 
coupler of the tractor. Leave the hoses in the hose retainer 
rod. 

•  Re-install the protective plugs in the tractor’s hydraulic cou

-

plers, and push the protective caps onto the male couplers of 
the loader hoses.

•  Re-start the tractor and carefully back the tractor away from 

the front loader.

•  Re-install the mounting pins in the front mount receiver and 

secure with the two lynch pins.

Warning: Do not climb or lean on the loader 
while it’s in a stored position. Keep children and 
bystanders away from the stored loader.

disMounTing THe loader 

Warning: a stored loader can fall and cause 
serious injury or death. Securely store loader and 
attachments on a hard level surface to prevent 
falling.

Warning: To provide necessary balance, the 
loader bucket must be installed before attaching 
or detaching from tractor, or when loader is in 
stored position.

iMPOrTanT:

the bucket must be installed to remove and 

re-mount the loader.

Move the tractor and loader to a firm, level storage site.

•  Using the implement control lever, level the bucket and lower 

it to the ground to take the weight off the mounting pins  
securing the loader hitch bracket in the front mount receiver. 
Set the tractor’s parking brake.

•  Remove the two lynch pins and withdraw the two mounting 

pins that secure the loader hitch bracket in the front receiver. 

Refer to Figure 13.

•  Carefully use the control lever to raise the boom and lower the 

loader hitch bracket out of the front receiver. 

seCTion 9: disMounTing and MounTing THe loader

Lynch Pin

Mounting

Pin

Front Mount

Receiver

Loader Hitch

Bracket

LH Mount

LH Mast

Center of

Support

Plate

figure 13