Cub Cadet 59A40051727, Operator'S Manual

11

Raise the front hitch so that the snow blower is off the 

22. 

ground; then stop the tractor engine and engage the parking 
brake.
Check to verify that the snow blower pin is fully seated into 

23. 

the front hole of the ‘A’ frame. If not, push the pin rearward to 
fully engage the ‘A’ frame.

Lower the blower to the ground then mount the snow blower 

24. 

drive shaft to the stub shaft by sliding the pulling the locking 
collar back and sliding the PTO on to the stub shaft until the 
PTO locks.. See Figure 8. 

WARNING! Do not attempt to connect the drive 

shaft when the tractor engine is running. Stop the 

tractor engine, disengage all PTO controls, en-

gage the parking brake, and wait for all movement 

to stop before connecting the snow blower drive 

shaft.

Stub Shaft

Drive Shaft

‘A’ Frame not show for clarity

figure 8

Mounting the Chute

NOTE:

 Grease the chute base before attaching. See Figure 9.

The chute was shipped with two of the chute clamps attached. To 
attach the chute, place it onto the chute base and secure it with 
the one remaining chute clamp using the clamp, spacer, 

1/4-20 x 

1.00 

carriage screw and 

1/4-20 

hex lock nut from the screw pack. 

See Figure 9.

Mounting the Chute Crank

To mount the chute crank you will need to two 3/8-16 x 3.50 Hex 
Screws and two 5/16-18 x .1.00 hex bolts.

Mount the chute crank to the side of the chute base with the 

1. 

hex screws. See Figure 10.

Mount the support tube on the horizontal bracket below the 

2. 

chute base using the 5/16-18 x 1.00 bolts and flange nuts. 
See Figure 10.

Chute

Spacer

Clamp

Hex Screw

Chute Base

Hex Lock Nut

Mounting Holes

Bottom of Chute

figure 9

Support Tube

Chute Crank

Hex Screws

Hex Bolts

figure 10