IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING THE UNIT.
Removing Unit From Carton
Assemble The Unit
Starting The Unit
Insert upper blower tube
into blower outlet and turn
clockwise until it locks into
place.
Place the lower blower tube
onto upper blower tube and
turn clockwise until it locks
into place.
Assemble The Unit
Place unit on a level surface.
Fill fuel tank.
Press primer bulb 10 times,
or until fuel is visible
Move choke lever to
Position 1.
DO NOT squeeze throttle
control.
Pull rope 5 times.
Move choke lever to
Position 2 .
Pull rope 3-5 times to start
engine.
Squeeze throttle
control and allow unit to
warm up for 30 - 60
seconds.
Continue to squeeze
throttle. Move choke lever
to
Position 3.
Continue to squeeze
throttle. Warm unit for an
additional 60 seconds to
complete warm-up. Unit
may be used during this
time.
11
2
Remove all contents from
the carton.
5
6
7
19
10
3
Place the unit on a level
surface, remove the oil plug
from the crankcase, and pour
the entire bottle of oil into the
fill hole.
Crouch in starting position.
8
4
Starting The Unit
11
12
13
14
10 X
5 X
3-5 X
Starter Rope
Blower Outlet
Throttle Control
On/ Off Switch
Upper Blower Tube
Lower Blower Tube
DIDN’T START?
Repeat these instructions.
IF engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to operator’s
manual for additional starting and
troubleshooting information
Primer
Bulb
Primer Bulb
Oil Plug
No Tools Required
for Blower Assembly*
*For vacuum assembly, refer to
the Assembly section of the
operator’s manual.
BV428
4-Cycle Suitcase Blower/Vacuum
Operator’s Manual
769-08089 P00
03/12
NEED HELP?
Call 1-877-282-8684 in U.S. or 1–800–668–1238 in Canada
ENGLISH — P
AGE 1
FRANÇAIS — P
AGE 7
ESP
AÑOL — P
AGE 13
Summary of Contents for BV 428
