Operation
4
10
Broadcast Sprayer Mode
1.
If not already running, start tractor.
2.
To engage broadcast sprayer mode,
rotate valve control to “ON“ position. See
Figure 4-15.
Figure 4-15
3.
Move harness control to “ON” position to
start pump. See Figure 4-16.
Figure 4-16
Note:
Spot sprayer wand is functional
during broadcast sprayer mode.
4.
Move harness control to “OFF” position
to stop pump. See Figure 4-17.
Figure 4-17
5.
Disconnect the battery wire harness from
the pump wire harness when not in use
to prevent accidental battery drainage.
See Figure 4-18.
Figure 4-18
Drain
1.
To drain excess fluids from the sprayer
tank, unscrew the cap located on the
bottom of the tank. Once drained,
make sure that the o-ring is in place and
tighten drain cap. See Figure 4-19.
Figure 4-19
