CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
6.3.7
Date: 04/29/2009
Page: 3
PROBLEM
PROBABLE CAUSE
REMEDY
Brakes drag (continued)
Bent or cracked torque plate
Replace
Corroded anchor bolts and/or
torque plate bushings
Clean and lubricate or
replace
Warped brake disc; inspect by
laying a straight edge across
disc face
Replace and use caution
during operation to prevent
excessive energy input into
brake
Out of position / stuck lining
Repair or replace
Restriction in hydraulic line
Isolate and remove restriction
Lining not firmly seated flush
against pressure / back plate
Deburr rivet hole on surface
adjacent to lining
Brakes inoperative
Brake fluid level low
Replenish brake fluid
Air in brake system
Bleed brake system
Worn brake linings
Replace linings
Defective caliper
Replace caliper
Defective master cylinder
Replace master cylinder
Leaky brake line connections
Tighten or replace connectors
Parking brake inoperative
Parking brake valve defective
Replace valve
Unable to obtain sufficient
hydraulic brake pressure,
excessive toe pedal
travel, or spongy pedal
Air in hydraulic system
Check for source, then bleed
hydraulic system
Leak in system; brake, master
cylinder, fittings, or lines
Locate leak and repair
Defective brake line (ballooning)
Replace
Defective master cylinder
Replace or repair
Back plate bolts loose or not
properly torqued, causing
excessive brake deflection
Torque bolts to proper value
Excessive rusting, scoring, or
pitting of brake disc
Clean or replace disc
Excessive back plate deflection
caused by bent bolts or over
torquing bolts
Check and replace bolts
Incorrect lining and/or disc
Replace with correct parts
Defective caliper
Rebuild caliper
Rapid disc and lining
wear
Excessive rusting, scoring, or
pitting of brake disc
Clean or replace disc
Excessive back plate deflection
caused by bent bolts or over
torquing bolts
Check and replace bolts
Summary of Contents for CARBON CUB SS CC11-160
