CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.3.8
Manual number SSC10000AMM
Page: 4
Date: 10/28/2010
(3) INSPECTION
(a) Axle
Visually inspect the axle to make sure there are no cracks or grooves.
(b) Tire and Tube
Visually inspect the tires inside and outside for cuts, uneven or excessive
wear, and penetration by foreign objects.
Visually inspect the inner tube for wear, cuts or cracks. Pay close attention to
the valve stem base.
The tire should be removed when the tread is worn to the base of a groove.
Tires with wear through the top fabric layer can only remain in service long
enough to return to a maintenance base to be replaced.
(c) Wheel Halves
Inspect the wheel halves for cracks or corrosion.
(d) Discs
Inspect the brake disc attachment points for cracking or distortion.
New disc thickness is .190, minimum disc thickness is 0.170 in.
(e) Bearings
Clean all metal parts (including the bearings) in a cleaning solution. Dry all
parts with compressed air.
Inspect the bearing and races for wear or damage. Replace if necessary.
(f) Replace unserviceable parts as required.
Summary of Contents for CARBON CUB SS CC11-160
