CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.3.15
Manual number SSC10000AMM
Page: 10
Date: 04/18/2013
1.
– Detent Holes
2.
– Snap Ring
3.
– Barrel
4.
– Detent Balls and Springs
5.
– Small O-Ring
6.
– Large O-Rings
Refer to Figure 6.3.15.6
(e) Rotate the shaft so the detent balls (4) are between the detent holes (1).
(f) Remove the snap ring (2) holding the handle barrel (3) in the housing.
(g) Carefully pull the barrel (3) out of the housing with fingers positioned to catch
each set of balls and springs (4)
.
(h) Remove the small O-ring (5) and the large O-rings (6), then clean the barrel.
(i) Inspect for wear and grooves.
(j) Replace the small O-ring (5) and the large O-rings (6) with new and lube on
installation.
(k) Insert the barrel (3) part way in the housing.
(l) One set at a time, insert a spring with a ball (4) on each end and push the barrel
the rest of the way in.
(m) Secure with the snap ring (2).
(n) Check the operation for positive detent and smooth turning.
(o) Remove the rag.
(p) Reattach the cover and the handle stop plate with the springs and the handle.
(q) Check to make sure the handle stop is working properly.
Figure 6.3.15.8: Fuel Selector Detail
Summary of Contents for CARBON CUB SS CC11-160
