CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.3.17
Manual number SSC10000AMM
Page: 8
Date: 04/18/2013
(4) INSTALLATION
(c) Place the battery in the mounting space.
(d) Connect the positive lead.
(e) Connect the ground lead.
(f)
Reinstall the pilot’s seat by securing with the pins.
5
IGNITION BACKUP BATTERY
The battery is a 12 Volt lead acid battery. It is sealed and does not require electrolyte
replenishment.
(1) REMOVAL
(a) Remove right forward interior panel.
(b) Release 4 quick-turn fasteners and remove battery cover bracket.
(c) Remove battery.
(d) Disconnect terminals.
(2) INSPECTION
(a) Inspect the battery and terminals for condition and corrosion.
(b) Clean as required.
(c) If necessary, charge the battery in accordance with the following instructions.
(3) CHARGING
NOTE
Charging should be conducted in an environment between 70º F and 90º F (20ºC and 30ºC).
The battery capacity may vary if charged outside of this recommended temperature range.
NOTE
If battery becomes very hot to touch, cease charging and allow battery to cool down.
NOTE
Voltage reading should be a minimum of 12.5-13.0 volts after charging. If voltage reading using
voltmeter is not 12.5 volts or more, repeat charging cycle.
Summary of Contents for CARBON CUB SS CC11-160
