CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.A
Manual number SSC10000AMM
Page: A10
Date: 01/31/2011
Operational/Functional Inspection Report
Initials
Notes
10 Pull Carburetor Heat Knob:
- Engine RPM should show a slight drop.
11 Apply a Load to the Electrical System (e.g. switch on landing
light):
- Observe that voltage remains constant and amperage
increases when load is applied (if ammeter installed).
13 Ignition Battery Backup System (if installed):
- Switch key to R position.
- Flip "RT IGN BACKUP BATTERY" switch to "EMERGENCY"
position. Should have no change to engine performance.
- Amber Light should illuminate.
- Flip "RT IGN BACKUP BATTERY" switch to "NORMAL"
position.
- Switch key to BOTH
14 Check the radio for proper Nav and Com operation.
15 Check the transponder for proper operation.
16 Verify proper ELT operation.
17 Set throttle to idle:
- Engine should idle between 500 and 750 RPM.
18 Set 1000 RPM.
19 Turn engine off by slowly pulling mixture control.
NOTE
An increase in RPM prior to the control reaching idle cut-off
position indicates proper air fuel mixture.
Summary of Contents for CARBON CUB SS CC11-160
