18
The lamp can be controlled by the button on the light head or with the remote control. The
remote control has a reach of roughly five metres.
Ex works the remote control is already paired with the light head. To connect the lamp with
a new remote control, connect the light to battery and hold the button on the lamp and the
button on the remote control for five seconds simultaneously. When the lamp lights up, the
pairing is finished.
attentIon!
SOS is an emergancy signal! Misuse may be prosecuted!
Button-leD:
Blue LED on:
Lamp on
Red LED on:
20% - 10% remaining capacity
Red LED flashing:
10% - 0% remaining capacity
If the battery capacity goes below 20%, the lamp will switch to Mid Power mode to save
energy. By pressing the button again you can return to high-power mode.
If the battery capacity goes below 10%, the lamp will switch to Low Power mode to save
energy. By pressing the button again you can return to high-power mode.
If the battery capacity goes below 5%, the lamp will switch to Ultra Low Power mode to
save energy. It is no longer possible to switch to other modes.
cautIon!
If the battery is totally discharged, the lamp will switch off.
note!
In a discharged state there is a risk of deep discharge. Recharge the battery as soon
as possible.
MoDe
outPut
runtIMe
High
1600 lm
2 h
Mid
800 lm
4 h
Low
300 lm
8 h
Ultra Low
100 lm
30 h
Flash
1000 lm
6 h
SOS
1000 lm
13 h
Alpine distress signal
1000 lm
105 h
sWItch on
Press the button
sWItch oFF
Keep the button pressed for 1 second
lIghtIng MoDes
High Power - Mid Power - Low Power
Press the button to switch
ultra loW PoWer
Keep the button pressed for 3 seconds
sPecIal MoDes
Flash - SOS - Alpine distress signal
Keep button pressed for 5 seconds
Press the button to switch
oPeratIon lIght
