Copyright Reserved HyVISION System Inc.
This document is Quick Start Guide (151001,En). To improve quality of product, this could be revised without
prior notification or consent.
HyVISION System is not liable for any losses resulted from the use of the document or any errors or offering
.
5
[1] Teflon tube
Path to feed the filament into the Extruder. (Be cautious not to bend it)
[2] Extruder
The part to move and extrude the molten filament.
[3] Clean filter case
The part to mount the clean air filter.
[4] Heated Bed
Bed platform to print out the object.
[5] Internal LED ambient light
LED light to show the internal status of the printer.
Heated Bed
[B1] Nozzle cleaning brush
Brush to clean the nozzle end at the beginning of the printing. (Heat resistant
rubber)
[B2] Bed position fixing Pin
(3 spots)
Pin to position of heated bed.
* Please make sure the pin is mounted at 3 spots on the bed.
[B3] Level point (3 spots)
Point to check the bed leveling.(Uncoated 3 spots)
* Please be clean on these 3 spots because Auto Leveling fails with the
contaminants on 3 spots.
Do not touch the nozzle of extruder and heated bed being heated up while printing.
Internal Parts and Heated Bed
B1
B3
B2
2
4
3
5
1