CUBICON Style Plus-A15 Series
User Manual
Mounting the Filament Spool
1
Prepare the filament spool to be used.
Remove a fixing tape on the filament, and cut
off the filament that has been bent. Be cautious
not to damage NFC tag
(marked with a red
dotted circle)
during the process. Also be
cautious not to let the filament get loosened
until the spool is mounted.
Check whether the
direction of the NFC tag is correct, which is to
be in the opposite direction from the label.
2
Insert the spool holder into the spool holder
mounting hole at the rear of the printer.
Mount the spool holder accurately so that it
doesn’t fall out.
③
Insert the filament spool into the spool holder, and
insert the filament into the filament inlet of the automatic
feeder up to the dotted line.
Be cautious about the rotation of the spool and the
insertion direction of the filament when mounting the
spool. Also, be cautious not to damage NFC.
④
Insert the filament into the filament feeder up to the
dotted line so that auto loading can be operated.
Maintain the state of the Teflon tube as it is mounted
to the extruder module.
23