CUBICON Style Plus-A15 Series
User Manual
Disassembly of the Extruder Module
1. How to Maintain the Nozzle in a Good Condition
2. Cleaning the Inside of the Nozzle using the Loading
3. Cleaning the Inside of the Nozzle Using the Nozzle Management Pin
4. Cautions regarding the Use of the nozzle Management Pin
5. Cleaning the Outside of the nozzle
Replacing the Nozzle Kit of the Extruder Module
Maintenance of the Heating Bed
Filament Can’t Be Discharged through the Nozzle.
Data in a USB Drive Can’t Be Viewed.
Data in a USB Drive Can’t Be Printed.
When Printing, the Printing Doesn’t Progress as Auto Leveling Fails.
The Function of Filament Existence Detection Sensor Doesn’t Work Normally.
Filament Auto Loading Function Doesn’t Work.
It Can’t Recognize a Genuine Filament
Operation Gets Interrupted during Printing
Problems in the Printout and the Operation Errors
Network Connection Can’t Be Made between Cubicreator and the Device
A Sculpture Doesn’t Get Adhered to the Base (Heating Bed) and It Gets Taken Off.
The Part of a Sculpture, Mostly the Edge of the Base Gets Taken Off from the Bottom 68
Middle of a Sculpture Gets Cracked.
A Sculpture Can’t Be Taken off from the Floor (Heating Bed).
4