IV. Mounting Weights
(See Appendix 3)
1. Remove the rod stop plate on mount purple.
2. Loosen weight clamping knob to allow room to slide weight onto rods.
WARNING: Be careful not to fully remove weight clamp, weights are heavy.
3. Tighten weight clamp knobs.
Alternative weight positions, mounting on a 45 degree angle:
1. Remove weight bars clamping knobs on top weight.
2. Turn weight bar once face, then tighten clamping knobs.
3. Add weight as described above.
V. Monitor and Hood
(See Appendix 4)
Monitor:
1.
Adjust the 19mm rods forward to allow room to attach the hardware:
1
a. Loosen rod clamping knobs
b. Pull rod system forward
c. Tighten rod clamping knobs again for monitor mounting.
2.
Loosen the monitor locating bosses
2
3.
Drop the monitor into the bosses then tighten bosses
3
Hood:
4.
Extend the hood mounting rods so they extend downward to allow room to mount
hood onto mount purple.
a. Loosen hood rod clamping knobs
b. Drop hood rods to furthest position to allow room to mount
c. Tighten hood rod clamping knobs.
5.
Drop hood rod bosses into hood receptacles on mount purple.
6.
Tighten hood bosses to fasten hood.
7.
Loosen hood rod clamping knobs to drop hood into proper position.
a. Tighten clamping knobs into place.
Final Adjustment:
8.
Loosen mount purple rod clamping knobs
9.
Slide hood and monitor setup back into position over camera lens, making sure
to center lens in hood resting just behind glass.
10.
Position lens shroud around camera lens to block all outside light from inside
hood.
