Instruction for use and installation
Gas Snack Plate
PS 400G-PS 600G-PS 900G
Description of the appliance
The griddles snacks are available in three models. The heating of the griddle is made
thanks to burners witch allowed a homogenous temperature.
These appliances are for professional use and must therefore be used by qualified
personnel.
They must be installed in accordance with current regulations by a qualified installer.
Unpack the appliance carefully from its original packaging. Place it on a flat surface.
The identification plate is located on the back of the appliance.
Dimensions and capacity
Appliance
Dimensions
(mm)
Dimensions of the
cooking area (mm)
Weight
PS 400 G
420x450x190
400x400
17 Kgs
PS 600 G
620x450x190
600x400
27 Kgs
PS 900 G
920x450x190
900x400
37 Kgs
Technical data
Appliance
Heat output
Number of
burners
PS 400 G
3.2 Kw
1
PS 600 G
6,4 Kw
2
PS 900 G
9.6 Kw
3
Operation
Lighting
- Press the knob in for a few seconds
- Place a flame close to the burner
- Keep the knob pressed in for a few more seconds
- The burners will then remain lit, now adjust the appliance to the setting
required.
A thermocouple cuts off the gas supply if one of the burners goes out.
The appliance has a factory-adjusted low flame setting.
Care and maintenance
Your appliance should be cleaned regularly with a damp sponge.
Do not clean your appliance under running water: water entering the system might damage it.
For improved service, we advise that periodic maintenance checks are carried out by a qualified
installer.
Your appliance can operate on liquid petroleum gas or natural gas. To change from one gas to
another requires the intervention of a qualified installer.
Installation
NB:
The side panels of your appliance must not be placed next to a wall or partition made
from a combustible material, otherwise, they should be covered in an effective heat insulating
material.
A distance of 10cm from the partition is deemed sufficient
Gas connection
The appliances operate on the following gases: Butane G30, Propane G31, natural gas G20/G25
and at all pressures encountered on mains gas. Connection is with a ½ thread. The appliances are
supplied from the factory with a Butane/Propane injector corresponding to category II2E+3+
The heat output of the appliance is:
PS 400 G
3.2 Kw
PS 600 G
6,4 Kw
PS 900 G
9.6 Kw
WWW.CUISIMAT.BE
