24
CARE AND MAINTENANCE
Cleaning Main Burner
To prevent flash backs and good performance of burner, the procedure below should be followed at least
once a month in late summer or early fall when spiders are most active or when your griddle has not been
used for a period of time:
1. Turn off at control knobs and LP cylinder.
2. Remove the griddle surface.
3. Remove the screws from the rear of the burners. Detach ignition wire from the ignition pin by hand only.
DO NOT use tool. Then Lift burner slowly.
4. Check all burner ports are clear of clogs. Use of a pin or paper clip works well.
5. Ensure the end of the burner and primary air screen are clear from insect nests, dirt or debris. Using a bent
stiff wire in the shape of a hook , or a bottle brush, run it through the burner tube and inside several times to
remove any debris.
6. Inspect each burner for damage (cracks or holes) and if such damage is found, order and install a new burner.
