5
BEFORE FIRST USE
It is recommended to charge the wine preserver for at
least 12
hours before first use. Please follow the instructions below
to charge the product:
This appliance is 120 volts only and should not be used
with a converter.
1. Take out the charging adapter and charging base.
Insert the charging adapter DC jack to the charging
base (at back of the base).
2. Place the wine preserver in the charging base,
making sure that it is firmly in position and fully
engaged with the charging base.
3. Insert the charging adapter into the power socket.
The charging light in the base will turn on to indicate
the unit is charging. It will take at least 12 hours
to fully charge the unit. Charging light will remain
red during the charging process, even when fully
charged.
OPERATING INSTRUCTIONS
To vacuum-seal a partially empty bottle of wine:
1. Insert the stopper into the mouth of wine bottle,
pushing down until it fits firmly.
2. Set the date dial from 1 to 31, to mark the date wine
was sealed.
3. Position the wine preserver over the wine bottle and
stopper and push down gently, holding the preserver
as straight as possible.
4. When the sealing process is completed, the wine
preserver will automatically stop.
5. Remove the wine preserver and return it to the
charging base when done. This will protect and
charge the unit while not in use.
NOTE:
Please hold the wine preserver as straight as
possible. If the position of the wine preserver is not
