SPECIAL CORD SET
INSTRUCTIONS
A short power-supply cord is provided to
reduce the risks resulting from becoming
entangled in or tripping over a longer cord.
Longer extension cords are available and
may be used if care is exercised in their use.
If a long extension cord is used, the marked
electrical rating of the extension cord must
be at least as great as the electrical rating of
the appliance, and the longer cord should be
arranged so that it will not drape over the
countertop or table top, where it can be
pulled on by children or tripped over.
NOTICE
This appliance has a polarized plug (one blade
is wider than the other.) To reduce the risk of
electric shock, this plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician.
Do not modify the plug in any way.
OPERATING NOTICE
Clogging and backing up of water and/or
coffee in the filter basket can occur under
any or a combination of any of the following
conditions: The use of too finely ground coffee,
using two or more paper filters, using the gold
tone filter in conjunction with a paper filter or
not properly cleaning coffee grounds from the
gold tone filter, or allowing coffee grounds to
spill over the filter.
Caution: Never open the top cover during the
brewing cycle, even if no water is draining from
the filter basket, since extremely hot
water/coffee can spill out from the spreader
and cause injury. If water/coffee is not draining
from the filter basket during the brewing cycle,
unplug the unit and wait 10 minutes before
opening the top cover and checking the filter
basket.
IMPORTANT UNPACKING
INSTRUCTIONS
1. Place the box on a large, sturdy flat surface.
2. Remove the instruction book and any other
literature.
3. Turn the box so that the back side of the
coffeemaker is down and slide the
coffeemaker from the box.
4. After the coffeemaker has been removed,
place the box out of the way and lift off the
top two polyfoam inserts.
5. Remove the cardboard insert between the
carafe lid and Brew Pause mechanism by
slding it out of the unit.
6. Grasp the carafe by its handle, remove it
from the heater plate and remove the
polybag.
7. Lift the coffeemaker off the remaining two
inserts and remove the polybag covering
the coffeemaker.
We suggest you save all packing materials in
the event that future shipping of the machine is
needed. Keep all plastic bags away from
children.
2
