6
INSERTING THE
WATER FILTER
Your coffeemaker comes with a charcoal water
filter that eliminates chlorine, bad tastes and
odours from tap water.
• Remove the filter from polybag and soak it,
fully immersed, in cold tap water for
15 minutes.
• Lift the water filter holder out of the
water reservoir.
• Press down on the filter compartment and
pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running cold tap water
through holes in bottom of compartment
for 10 seconds.
Allow the filter to drain completely.
• Slide the water filter holder back into
the channel in the water reservoir, pushing
it down to the base of the unit.
NOTE:
We recommend changing the water filter
every 60 days or after 60 uses, and more often
if you have hard water. Replacement filters can
be purchased in stores, or by calling Cuisinart
Consumer Service, or at www.cuisinart.ca.
GETTING TO KNOW
YOUR CONTROL PANEL
1. Power ON/OFF
Press to turn the brewer on and off.
2. Grind Button
Press to automatically start or stop
grinding coffee into the HomeBarista
®
Reusable Filter Cup. Turns off when
grinding is complete.
3. Add Water Indicator
Indicator will illuminate Red when
water level is low. The indicator turns
off when the water reservoir is filled
past minimum level.
4. Brew Size Buttons
Select from 8 oz., 10 oz., or 12 oz.
[235 ml, 295 ml or 355 ml] cup size to
begin brewing.
Coffeemaker Charcoal Water Filter and Holder
1
2
3
4