6
Note:
The Count Up/Down Timer
will begin counting when the desired
speed or function button is pushed. When you switch into a pre-pro-
grammed speed or function, the timer will reset to support the new com-
mand. You can adjust the run time when choosing High or Low speeds, by
pressing up or down arrows. To activate, press the speed button. The LCD
will start counting down from your chosen time. Smoothie and Ice Crush
function keys will count down. Low and High speed keys will count up to 3
minutes if no time has been chosen.
Note:
At the end of the designated cycle, High or Low, the unit will go into
Standby mode. To activate, press High or Low again to start a new cycle.
8.
PRE-PROGRAMMED FUNCTIONS:
Smoothie and Ice Crush are
programmed based on extensive testing in our kitchen and engineering
lab.
a) Smoothie:
Start by powering the unit on and pressing Smoothie. The
LED backlight will illuminate and the 1-minute countdown program will
begin. You may stop the program at any time by pressing the Smoothie
button again or by powering the unit off.
b) Ice Crush:
From the Standby mode, press Ice Crush. A pre-pro-
grammed cycle will begin. It is designed to run for 10 seconds and will
automatically stop. The blender will go back into Standby mode.
Note:
We recommend you use a maximum of 14 cubes per cycle.
9.
TO DISLODGE FOOD:
Use a plastic spatula to help remove food lodged
around the cutting assembly.
DO NOT USE SPATULA UNTIL YOU HAVE
TURNED THE BLENDER OFF.
Replace the cover and removable measuring
cup and continue blending, if necessary. Make sure spatula is not inside the
blender jar before blending.
10.
WHEN FINISHED BLENDING:
Press the On/Off button and unplug the
blender from the electrical outlet. Never remove the blender jar from the
jar pad until the blender is off. Simply lift blender jar from jar pad.
Do
not put hands into blender jar with blender plugged in.
11.
In the event the blender loses power and shuts off, simply unplug the
unit and then plug it back in. Press On/Off to power the unit on. If the
unit has overheated, let it cool down (15 minutes) before powering on.
CLEANING AND MAINTENANCE
Always unplug your Cuisinart
®
Hurricane
™
from the electrical outlet before
cleaning. The blender is made of corrosion-resistant parts that are easy
to clean. Before first use and after every use, clean each part thoroughly.
Periodically check all parts before reassembly. If any part is damaged or
blender jar is chipped or cracked, DO NOT USE BLENDER.
Remove the blender jar from the jar pad by lifting straight up and away, and
hand-wash.
CAUTION:
Remove the blender jar cover and the removable measuring
cup. Wash in warm, soapy water; rinse and dry thoroughly, or place in
upper rack of dishwasher. The blender jar must be washed in warm, soapy
water and rinsed and dried thoroughly. The blender jar can also be placed
upside down in dishwasher.
Finally, wipe the motor base clean with a damp cloth to remove any residue,
and dry thoroughly. Never submerge the motor base in water or other liquid,
or place in a dishwasher.
Tip:
You may wish to clean your blender blade assembly as follows: Squirt
a small amount of dishwashing liquid into assembled blender jar and fill with
24 ounces warm water. Run on Low for 15 seconds. Repeat, using clean tap
water. Empty blender jar.
Any servicing should be performed by an authorized service representative.
DOs and DON’Ts WHEN USING YOUR BLENDER
Do:
• Make sure the electrical outlet is rated at the same voltage as that stated
on the bottom of the blender motor base.
• Always use the blender on a clean, sturdy and dry surface.
• Always add liquid ingredients to the blender jar first, then add remaining
ingredients. This will ensure that ingredients are uniformly mixed.
• Cut most foods into cubes approximately ½ inch (1.3 cm) to 1 inch (2.5
cm) to achieve a more uniform result. Cut all cheeses into pieces no larger
than ½ inch (1.3 cm).
• Use the removable measuring cup to measure liquid ingredients such as
alcohol. Replace removable measuring cup after ingredients have been
added.
• Use a rubber or plastic spatula as needed, only when the blender is
