Culligan knows the more informed you are about your water treatment systems, the more confident you will be
about its performance. It’s because of this and more than seventy years of commitment to customer satisfaction that
Culligan is providing this Performance Data Sheet to its customers.
IMPORTANT NOTICE:
Read this Performance Data Sheet and compare the capabilities of this unit with your
actual water treatment needs. It is recommended that before purchasing a water treatment unit, you have your
water supply tested to determine your actual water treatment needs.
MANUFACTURER: Culligan International Company,
9399 W. Higgins Rd., Suite 1100, Rosemont, IL 60018 USA
1-800-CULLIGAN or 1-847-430-2800
PRODUCT:
Culligan Medallist Plus Series
®
60 Water Softener
with Soft-Minder
®
Meter
TESTING CONDITIONS & RESULTS:
Flow Rate:
10.2 gpm @ 15 psi
Capacity:
35,614 grains @ 8.0 lb. salt
Pressure:
30 - 40 psi
51,659 grains @ 16.0 lb. salt
Acidity:
Non-Corrosive
60,523 grains @ 24.0 lb. salt
Temperature:
68°F (20°C)
Efficiency Rated Dosage**:
4,451 gr./lb.
pH:
7.6
SOFTENER SPECIFICATIONS:
Max. Flow Rate:
10.2 gpm (38 Lpm)
Pressure Drop at Maximum Flow Rate:
15 psi (109 kPa)
Operating Temperature Range:
33-120°F (1-50°C)
Maximum Drain Flow Rate:
2.6 gpm (9.8 Lpm)
Oper. Press. Range:
20-125 psi (140-860 kPa)
Oper. Press. Range (Canada):
20-90 psi (140-620 kPa)
Name of
Substance
USEPA Maximum
Contaminant Level
pH
Flow Rate
Pressure
Barium
2.0 mg/L
7.5 + 0.5
10.2 gpm
15 (psig)
Radium 226/228
5 pCi/L
7.5 + 0.5
10.2 gpm
15 (psig)
This system is certified for barium and radium 226/228 reduction based on hardness reduction. It is recommended you test your
water every 6 months to ensure the system is performing properly and that hardness, and therefore barium and radium 226/228,
are being reduced. Hardness test strips have been included. Additional strips are available from your local Culligan dealer.
The Culligan Medallist Plus Series
®
60 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 44 for the
effective reduction of hardness (calcium and magnesium) and barium/radium as verified and substantiated by test data.
The Culligan Medallist Plus Series
®
60 Water Softeners are tested and certified by WQA against NSF/ANSI Standard 61 for
material requirements.
This softener is efficiency rated, it has a Demand Initiated Regeneration (D.I.R.) feature which complies with specific performance
specifications intended to minimize the amount of regenerant brine and water used in their operation. The softener has a rated salt
efficiency of not less than 3350 grains of total hardness exchange per pound of salt used (based on NaCl equivalency), and shall
not deliver more salt than its listed rating. The efficiency is measured by a laboratory test described in NSF/ANSI Standard 44. This
test represents the maximum possible efficiency that the system can achieve. Operational efficiency is the actual efficiency achieved
after the system has been installed. Operational efficiency is typically less than the efficiency due to individual application factors
including water hardness, water usage, and other contaminants that reduce the softener’s capacity.
Refer to the Specifications, Familiarization and Warranty section of this Owner’s Guide for more specific product information. To
avoid contamination from improper handling and installation, your system should only be installed and serviced by your Culligan
Man. Performance will vary based on local water conditions. The substances reduced by this system are not necessarily in your
water.
Culligan water softeners are designed to work with any salt of good quality, although it is recommended that you ask your local
Culligan Man for his suggestion on the best type and grade of salt to use in this softener.
NOTICE:
This softener is not intended to be used for treating water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
**The efficiency rated dosage is only valid at the 7.0 lb. salt dosage.
Buyer Signature _________________________________________________ Date ________________
Seller Signature _________________________________________________ Date ________________
Performance
Data Sheet
37
