16
fig.9.
fig.10.
EC
O
EC
O
P
D
K
6
7
1
2
3
Installation
Fig.9.
The electrical connection must be carried out
exclu-
sively
by qualified personnel after reading the safety
warnings at the beginning of the manual.
Before connecting the hood
check that the systems
the oven is connected to comply with the current
regulations
in the country of use.
Pass the hood cable with the connector
K
through the hole
you took the cap off previously
T
.
Block the cable with the locknut
D
.
Insert the male connector
K
of the hood into the female con-
nector
P
connected to the oven terminal board.
If required, the cable can be replaced by the Dealer or its
technical service or by a person with similar qualifica-
tions to prevent any risk.
Installed cable type (EU version):
3x1 mm
2
silicone cable, H07Rn-f three-pole cable for sin-
gle-phase cabling
Installed cable section (UL/CSA version):
16/3 cable ul aWM style 3644
from the
hood
Inserting the filters
Fig.10.
Insert the filters as shown in the figure.
