Name | model
Curly’s Ag –
Agricultural Innovations | www.curlysag.com | info@curlysag.com
Hand-E | 2022 MODEL
P a g e |
9
Step 4 - Wheel Installation
There are 3 different ways you can have your wheels set up on your Incinerator
Multi. Using two wheels will reduce the manoeuvrability of the Incinerator multi,
however it will increase stability. You may want to use one set up or the other at
different times or in different situations.
1.
ONE WHEEL
–
Insert the Axle bolt
(J)
though the hole in the middle of one
of the wheels
(E)
, then slide wheel and Axle bolt through the hole on the
Main frame / Gas Bottle Attachment. Make sure the wheel is on the side
where the Gas bottle holder is.
Do up the nut, ensure that you don’t over tighten the nut and bolt as this
will cause unnecessary drag and wear the bearings.
Spin the wheel to check that it spins freely but there is no free play.
You
will have more of Axle bolt
(J)
sticking out, this is for if you were to install
the second wheel.
Hole for
Axle Bolt
J
E
A
