Step 5. Install eFlux DC Flow Pumps
1.
Unpack all components
from eFlux DC Flow Pump box.
2.
Determine installation method
eFlux DC Flow Pump Installation
LOOP® Marine Bundle Kit
The eFlux DC flow pump can be installed either submersible (internal) or inline (external). If using
in a submersible application, please use the inlet pump screen (included).
Submersible
External Inline
3.
Install Pump
from eFlux DC Flow Pump box.
1
2
3
3
1.
Thread pump filter screen to inlet of the pump.
2.
Place O-ring inside the outlet barb fitting and quick
coupling. Thread barb fitting to pump and hand tighten.
Submersible (internal) Installation
3.
Connect return hose (not included) by sliding over barb
fitting. Ensure hose is secured using a hose clamp (not
included).
2. Place o-ring inside the outlet barb fitting and quick coupling.
Thread barb fitting to pump outlet and hand tighten.
Inline (external) Installation
3. Connect inlet hose (not included) by sliding over inlet barb
fitting. Ensure hose is secured by using a hose clamp (not
secure with clamp (not included).
1. Place o-ring inside the inlet barb fitting and quick coupling.
Thread barb fitting to pump inlet and tighten.
Fill sump with water and check for water/air leaks.
included.) Connect return hose to outlet barb fitting and
Fill sump with water and check for water/air leaks.
1
2
3
4.
Route DC pump cable to Power Center
(larger model #4302 includes a DC pump extension
cable if required.) Plug DC pump into pump connection on DC manifold HUB (gray HUB.)
5.
Adjust flow dial from 0-100%
until desire flow rate is
achieved. Note: eFlux DC Flow pumps have a slow
start up/ramp to full speed. Allow pump to run 30
seconds to reach adjusted flow.
eFlux DC Pump
Manifold HUB
NOTE: READ ALL SAFETY INSTRUCTIONS
INCLUDED WITH EACH PRODUCT
Connect to
Pump Input
4
Adjust
Flow
5
Page 8
