www.current-usa.com
PAGE 4 of 6
Programming Instructions
Please note: this timer uses a 24:00 Hr. clock (for example, 1:00pm = 13:00 hrs). The on/off times
must be within the same 24:00 day (i.e. do not program the lights to turn on/off on different days)
1. Press Set Clock, screen will blink for 3-5 seconds.
2. Press Hour+ until current hour is reached
3. Press Minute - until current minutes reached
4. Press Enter current time is now set
Programming time of day
SET
CLOCK
HOUR
+
MINUTE
-
ENTER
1. Press On Time, screen will blink for 3-5 seconds.
2. Press Hour+ and Minute- until desired On Time is reached
3. Press Enter scheduled On Time is now set
4. Press Off Time
5. Press Hour+ and Minute until desired Off Time is reached
6. Press Enter scheduled Off Time is now set
Note: At scheduled On Time, the Sa Pro LED will slowly ramp up over 15 minutes simulating a
gradual sunrise. At the Off Time, the LED will slowly dim down over 15 minutes simulating a sunset.
Programming on/off time
ON
TIME
HOUR
+
HOUR
+
MINUTE
-
MINUTE
-
OFF
TIME
ENTER
ENTER
Program daylight color spectrum
1. Press Daylight
2. Press any of the pre-programmed color spectrums and customize the color and intensity
using the adjustment buttons until your desired color spectrum is acheived.
Please see page 6 for daylight color spectrum recommendations.
3. When the desired daylight color spectrum is reached, press Daylight and hold
for 5 seconds.
Light will flash, indicating the daylight color spectrum is now stored in memory.
4. Press RESUME key for light to go back into its normal 24-hour schedule, display will show “T-ON”.
Daylight
Daylight
RESUME
