20
21
CHANGING BATTERIES
Using two hands, carefully and slowly unscrew the BATTERY CAP g
[Fig. 23]. Batteries will naturally fall out of the battery tube.
Replace bad batteries with six (6)
new 1.5v Alkaline AA batteries.
Always replace all batteries.
NEVER mix old and new batteries.
Also, NEVER use damaged or
dropped batteries.
Figure 23; Unscrew Battery Cap
Figure 23.1, Insert Batteries
The SMART WAND™ will play a
short tune to confirm the batteries
have been installed correctly.
ATTACHING A SMART WAND™ HANDLE EXTENSION
Figure 24; Unscrew Battery Cap
Carefully remove the BATTERY
CAP g from the SMART WAND™
[Fig. 24]. Be sure not to remove
the batteries.
Figure 24.1; Screw on Extension
Attach
EXTENSION
HANDLE
K onto the end of the SMART
WAND™. Screw into place [Fig.
24.1].
Reattach BATTERY CAP g onto the end of the EXTENSION HANDLE
K . Screw into place.
Replace the BATTERY CAP g .
CONVERTING A
HORIZONTAL
CORDED TILT BLIND
First, remove the existing corded tilt gear from the blinds header. The
standard tilt gear assembly is shown in [Fig. 25].
Remove the tassels by either
cutting the cord or removing the
knots at the end of the cord [Fig.
26].
Typically, the tilt gear is removed
by sliding the rod out of the tilt
gear, slightly bending the header
and lifting the tilt gear out [Fig. 32].
Sometimes the rods are retained
in place through either a rod
pin, crimps or the end brackets.
While each manufacturer installs
these tilt gears differently, they
are relatively easy to remove. If
you find it difficult to determine
how to remove the corded tilt
gear, view our instructional video
located at
www.currentproductscorp.com\
support.
Figure 27; Remove Existing Gear by
Sliding Rod Out
Figure 26; Cut or Untie the knots
Many venetian blinds use a cord to tilt the slats instead of a wand.
To install the SMART WAND™ to these types of blinds, you must first
replace the corded tilt gear installed on your blind with the UNIVERSAL
TILT GEAR G included with your SMART WAND™ purchase.
Figure 25; Full Assembly
For further assistance with converting a corded tilt blind, please view
our online instructional videos.
We suggest removing your blinds from the window and performing
the next steps on a table or other flat surface.
