INSTALLATION
6
Installation
Location
When selecting a position for your unit you should make sure the floor is flat and firm, and
the room is well ventilated with an average room temperature of between 16°C and 38°C.
If the room temperature drops below 16°C your freezer may start to defrost. Avoid locating
your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it
may increase the electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly. This unit is not designed for use in a garage or
outdoor installation. Do not drape the unit with any covering.
Levelling the Unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the doors and magnetic seal alignments
will not be covered properly.
Installing the Spacers
Screw the spacers to the left and right side
of the unit’s rear part.
Free Space Requirements
When installing the unit, ensure that 50 mm
of free space is left at both sides, 100 mm
at the rear of the unit and 90 mm at the top
of the unit. The door can be opened to the
right or the left, depending on which best
suits the location. Please ensure there is
adequate space for the door to fully open to
160°.
Summary of Contents for CTT50W12
Page 1: ...INSTRUCTION MANUAL TABLE TOP FRIDGE CTT50W12 ...
Page 2: ......
