INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
EXISTING HARDWARE
(BOTH SIDES)
BUMPER BEAM
VEHICLE FRAME
EXISTING WELD NUTS
(BOTH SIDES)
1. On the underbody panel, remove (3) screws using a 10mm
socket and (4) screws using a screwdriver. Once removed,
mark out a 3.25" x 6" section using masking tape and trim
using aviation shears. Set aside for later reinstallation. NOTE:
Dimensions are approximate, confirm prior to reinstallation.
2. Inside the wheel well, locate and remove (2) screws
using a screwdriver. Once removed pull back wheel
well to reveal (5) screws. Remove (2) using a T25
torxbit socket and (3) using a screwdriver. Set wheel
well accent piece aside for later reinstallation.
3.25"
6"
Summary of Contents for 13291
Page 4: ......
